Thermal Sensors
|
This page summarizes known information about the locations and properties of thermal sensors on ThinkPad laptops. |
Accessing the sensors
ACPI system temperature sensors
The primary means of accessing the thermal sensors is through the ibm-acpi module, which provides up to 11 thermal sensors (some of which may be inactive) when loaded with the experimental=1 option. Up to eight thermal sensors are exposed at /proc/acpi/ibm/thermal:
# cat /proc/acpi/ibm/thermaltemperatures: 44 41 33 42 33 -128 30 -128
On some models there are three extra sensors at Embedded Controller offsets 0xC0 to 0xC2, which can be read by parsing /proc/acpi/ibm/ecdump:
# perl -ne 'm/^EC 0xc0: .(..) .(..) .(..) / or next; print hex($1)." ".hex($2)." ".hex($3)."\n"' < /proc/acpi/ibm/ecdump40 48 43
Future models might be additional extra sensors beyond those three. To see all candidates:
# perl -ne 'print join(" ",map(hex,m/\w+/g))."\n" if s/^EC 0xc0://' < /proc/acpi/ibm/ecdump40 48 43 128 128 128 128 128 0 0 0 0 0 0 0 0
A value of -128 (i.e., 0x80 hex) means the sensor is not connected. For example, in the first example above the two -128 values belong to the UltraBay battery, which is not plugged in).
HDAPS temperature sensor
The Active Protection System accelerometer also reports a temperature, which is identical to one of the ACPI sensors. The corresponding sensor is actually not inside the HDAPS chip, but fairly close.
# cat /sys/bus/platform/drivers/hdaps/hdaps/temp141
Harddisks SMART temperature sensor
Finally, the system hard disk temperature can be read through the disk's SMART interface:
# smartctl -A /dev/hda194 Temperature_Celsius 0x0022 145 097 000 Old_age Always - 31
Or, for SATA-equipped models running a recent Linux kernel (see Problems with SATA and Linux):
# smartctl -A -d ata /dev/sda194 Temperature_Celsius 0x0022 145 097 000 Old_age Always - 31
When the UltraBay Slim HDD Adapter or UltraBay Slim SATA HDD Adapter are used, the second hard disk will typically provide another temperature readout via its SMART interface, analogously to the above.
Utilities for viewing temperatures
The following utilities display the ThinkPad-specific thermal sensor readouts:
- The above shell commands.
- The "Sensors" builtin of gkrellm can show 6 specific ACPI sensors (out of up to 11).
- CPU Info is a KDE applet that can display the 8 first ACPI sensors as well as the HDAPS sensor. Limited to showing one sensor at a time.
- IBMDoK, another KDE applet. Shows 4 specific sensors (out of up to 11). So far only tested at the T60.
Sensor locations
This information is model specific.
ThinkPad R51
The ibm-acpi documentation includes the report by Thomas Gruber:
EC offset Index in "thermal" Location (estimated) 0x78 1 CPU 0x79 2 Mini-PCI 0x7A 3 HDD 0x7B 4 GPU 0x7C 5 Battery (main) 0x7D 6 Battery (device bay) 0x7E 7 Battery (main) 0x7F 8 Battery (device bay) 0xC0 none ? 0xC1 none ? 0xC2 none ?
ThinkPad T40
The location of one of the sensors is identified here.
EC offset Index in "thermal" Location (estimated) 0x78 1 CPU 0x79 2 System board under rear left corner of Mini-PCI module 0x7A 3 ? 0x7B 4 GPU 0x7C 5 Battery 0x7D 6 n/a 0x7E 7 Battery 0x7F 8 n/a 0xC0 none n/a 0xC1 none n/a 0xC2 none n/a
ThinkPad T43, T43p
Found by Shmidoax using cooling spray to cool down components and observe the effect on the sensors.
EC offset Index in "thermal" Location (estimated) 0x78 1 CPU 0x79 2 Between PCMCIA slot and CPU (same as HDAPS module) 0x7A 3 PCMCIA slot 0x7B 4 GPU 0x7C 5 System battery (front left = charging circuit) 0x7D 6 UltraBay battery? 0x7E 7 System battery (rear right) 0x7F 8 UltraBay battery? 0xC0 none Bus between Northbridge and DRAM 0xC1 none Southbridge (under Mini-PCI card, under touchpad) 0xC2 none Power circuitry, on underside of system board under F2 key
| Photos (click to see full size) |
ThinkPad T60
Found by Marco Kraus for use in IBMDok.
EC offset Index in "thermal" Location (estimated) 0x78 1 CPU 0 0x79 2 HDD 0x7A 3 HDD 0x7B 4 GPU 0x7C 5 Battery 0x7D 6 n/a 0x7E 7 Battery 0x7F 8 n/a 0xC0 none ? 0xC1 none ? 0xC2 none ?
The CPU thermal sensors seem to be exposed in both /proc/acpi/thermal_zone/THM0/temperature and /proc/acpi/thermal_zone/THM1/temperature, though the latter curiously seems to exist only in this file and nowhere in /proc/acpi/ibm/ecdump.
