Problems with SATA and Linux

Some ThinkPad models use a SATA controller for the system hard disk. This causes several complications for Linux installation. The following lists these problems and known workarounds. Note that the details are often version- and distribution-specific. Models using a SATA disk interface Models using a SATA controller and a SATA system disk: ThinkPad Z60t, Z60m Models using a SATA controller and a PATA (IDE) system disk with a SATA-to-PATA bridge: ThinkPad T43, T43p ThinkPad R52 ThinkPad X41, X41 Tablet NOTE! Some of these problems will be solved in Linux 2.6.15. See the SATA driver features, software status and hardware status. Hang on resume from suspend to RAM Linux kernels (as of 2.6.15-rc3) do not support suspend and resume for SATA devices. As a result, the machine hangs upon the first disk access after resume. A kernel patch (LKML posting) fixes this by adding SATA power management support. Patches Patch for kernel 2.6.12 Patch for kernel 2.6.13-rc5 Patch for kernel 2.6.14 Patch for kernel 2.6.15-rc4 Some distributions already include this patch (e.g., Ubuntu Breezy), but some don't (e.g., Fedora 4). Links RedHat Bugzilla bug 169201: "SATA drives fail on laptop suspend" Failed resume from suspend to disk Suspend to disk (using swsusp or Software Suspend 2) needs to load the memory image from the SATA disk. For this to work, you either need an initrd with all the necessary SATA modules, or the SATA drivers compiled into the kernel. DVD drive not recognized The ata_piix SATA driver grabs ownership over the IDE ports when it is loaded, but (by default) does not support PATA ATAPI devices such as the Ultrabay optical drives. Thus, if the ide driver is compiled as a module and loaded after ata_piix, the DVD drive will not be recognized by either driver. Either of the following configurations will work: For kernel 2.6.14 and newer: enable ATAPI support in the SATA system using libata.atapi_enabled=1 (see below; this is experimental). Compile IDE into the kernel (non-module). Compile both IDE and SATA as modules and make sure IDE is loaded first (the module is called 'ide_generic'). Note that the optical drive must be in the Ultrabay during system boot (Ultrabay device swapping is currently unsupported). No DMA on DVD drive Using the IDE driver, DMA support cannot be enabled on an Ultrabay optical drive: # hdparm -d1 /dev/hdc /dev/hdc: setting using_dma to 1 (on) HDIO_SET_DMA failed: Operation not permitted using_dma = 0 (off) As a result, the optical drive is slow, and in particular, too slow to play video DVDs. One workaround is to use employ the SATA driver (instead of the IDE driver) for the optical drive. This requires enabling two featues of the SATA driver, namely ATAPI support and PATA support, which are both in active development and far from stable. Using this will probably devour all your data and go on to eat all the food in your fridge. But if you have full backups and an empty fridge, do the following: Grab the latest kernel (must be 2.6.14 or newer; the relevant code is under active development). Do one of the following: Configure the SATA system (and in particular ata_piix and libata) as built-in and add libata.atapi_enabled=1 to your kernel command line (e.g., in in /boot/grub/menu.lst). Configure the SATA system as module (this is often the default) and add "options libata atapi_enabled=1" to your /etc/modprobe.conf (or the equivalent in your distribution). Do one of the following: Disable the IDE system. Build the IDE driver as built-in (this is often the default) and add the hdc=noprobe kernel argument (e.g., in in /boot/grub/menu.lst). Build the IDE driver as module and add "options ide hdc=noprobe" to your /etc/modprobe.conf (or the equivalent in your distribution). If you chose to use modules above, regenerate your initrd file. If this doesn't work, use lspci -vn to check whether one of the following chipsets is used in the Thinkpad: PCI ID Name 8086:7111 Intel 82371AB/EB/MB PIIX4 IDE 8086:24db Intel 82801EB/ER (ICH5/ICH5R) IDE Controller 8086:25a2 Intel 6300ESB PATA Storage Controller If yes, enable support for these chipsets has to be enabled by setting #define ATA_ENABLE_PATA in include/linux/libata.h (and report your ThinkPad model in the discussion page). There have been reports that DVD burning doesn't work under this configuration, but it seems to work with kernel 2.6.14 and later (tested on a ThinkPad T43 and T43p with a UltraBay Slim DVD Multi-Burner Plus). Links RedHat Bugzilla bug 163418: "can't enable DMA on DVD drive" No DMA on system hard disk In some Linux kernels, both the SATA driver and the IDE driver can handle the system hard disk. With the SATA driver, it shows as /dev/sda and DMA is enabled. With the IDE driver, it shows as /dev/hda and DMA is disabled. The simplest way to enable DMA is to force the IDE driver to ignore the system hard disk by passing the hda=noprobe kernel argument. The driver will then be handled by the SATA driver. Note that this will change its device name to /dev/sda (which may require changes in /etc/fstab and the boot loader) and may cause other problems as listed above. (Observed on a ThinkPad T43 with Fedora Core kernel 2.6.13-1.1526_FC4.) No SMART support Prior to kernel 2.6.15, the Linux SATA system did not support SMART commands (e.g., via smartctl). The capability was incorporated into Linux 2.6.15-rc1, and a patch is available for older kernels: Kernel 2.6.12: http://rtr.ca/dell_i9300/kernel/kernel-2.6.12/03_libata_passthru.patch Kernel 2.6.13: http://rtr.ca/dell_i9300/kernel/kernel-2.6.13/02_libata_passthru.patch Kernel 2.6.14 with the above suspend-to-RAM patch: http://linux.spiney.org/system/files?file=02_libata_passthru.fixed.patch 02_libata_passthru.fixed.patch is not appling correctly on newer kernels than 2.6.13. Here is the fixed patch: http://www.foo.fh-furtwangen.de/~koenigr/02_libata_passthru.fixed.again.patch After applying the patch, run smartctl with the "-d ata" parameter: # smartctl -d ata -a /dev/sda No disk power management Prior to kernel 2.6.15, the Linux SATA system did not support power management commands on these models. The above patches for SMART support resolves this, and in particular enables the following commands: # hdparm -y (spin down) # hdparm -S num (automatic spin down timeout) # hdparm -B num (advanced power management level) Note that this command is still rejected: # hdparm -M num (acoustic management) (Tested with patched kernels 2.6.13.1 and 2.6.12-4 and a 60GB 7200RPM disk model HTS726060M9AT00.) Note that even when Laptop-mode is used, the "hddtemp" daemon (as shipped with Fedora Core 4) will wake up the disk every minute, and must thus be disabled for power management to be effective. Its accesses are not visibile through the /proc/sys/vm/block_dump facility. It is unclear whether disk temperature can be monitored without causing the disk to spin up (on the T43, none of the /proc/acpi/ibm/thermal values corresponds to the disk's built-in temperature sensor). No disk information Prior to kernel 2.6.15, on these models the disk information could not be read by the standard commands such as: # hdparm -i /dev/sda # hdparm -I /dev/sda The latter is fixed by the above patch for SMART support. No swapping of UltraBay device The libata driver does not yet hot-swapping (or warm-swapping) of PATA devices. If you use a DVD or 2nd PATA HDD via the libata (SATA) driver, to swap them in or out you must power down the machine. If you use the ide driver for a PATA UltraBay device, hot-swapping might work using hdparm, idectl or hotswap (please report). However, DMA will be disabled on these models (see above). If you use a SATA device in the UltraBay, libata hot-swapping might work (please report). Swapping of the UltraBay Slim Battery does work. BIOS error 2010 on user-installed hard disk While not a Linux issue, note that there is an issue with installing alternative PATA (IDE) hard disks as the system drive. Unless the disk is one of the few approved disks listed inside the BIOS, you will get an BIOS error 2010 during system boot, and the disk may operate unreliably. See Problem with non-ThinkPad hard disks.