Difference between revisions of "Moving Ubuntu 10.04 to a ThinkPad X220"
(Initial version of this document) |
m |
||
| (5 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | Ubuntu | + | Perhaps you think that Ubuntu 11.04 has too many annoying changes |
| − | 11.04 has too many annoying changes (and some irritating bugs that affect | + | (and some irritating bugs that affect usability) |
| − | usability) to be considered as an option | + | to be considered as an option for use an a ThinkPad X220. |
| − | + | Suppose you have Ubuntu 10.04 installed on an older ThinkPad | |
| − | and want to move it to | + | and you want to continue using that. |
| + | |||
| + | Unfortunately, you can't just move the hard drive over. | ||
| + | First of all, a newer kernel is needed for the X220. | ||
| + | But in any case the X220 does not accept a 9.5mm-thick notebook drive | ||
| + | — | ||
| + | it needs one of the new 7mm slim drives. | ||
| + | |||
| + | Here are the steps to take. | ||
- boot the X220 with a Ubuntu 11.04 CD | - boot the X220 with a Ubuntu 11.04 CD | ||
| Line 34: | Line 42: | ||
[https://launchpad.net/~glasen/+archive/intel-driver glasen] as described | [https://launchpad.net/~glasen/+archive/intel-driver glasen] as described | ||
[http://www.thinkwiki.org/wiki/Installing_Ubuntu_10.04_%28Lucid_Lynx%29_on_a_ThinkPad_X220 here] | [http://www.thinkwiki.org/wiki/Installing_Ubuntu_10.04_%28Lucid_Lynx%29_on_a_ThinkPad_X220 here] | ||
| + | |||
| + | [[Category:Ubuntu 10.04]] | ||
| + | [[Category:X220]] | ||
Latest revision as of 19:34, 13 July 2011
Perhaps you think that Ubuntu 11.04 has too many annoying changes (and some irritating bugs that affect usability) to be considered as an option for use an a ThinkPad X220.
Suppose you have Ubuntu 10.04 installed on an older ThinkPad and you want to continue using that.
Unfortunately, you can't just move the hard drive over. First of all, a newer kernel is needed for the X220. But in any case the X220 does not accept a 9.5mm-thick notebook drive — it needs one of the new 7mm slim drives.
Here are the steps to take.
- boot the X220 with a Ubuntu 11.04 CD
- partition the disk in the X220 to your liking
- transfer your existing installation to the X220 disk over the network; I prefer using netcat + dump/restore, but rsync will work too
- chroot to your new installation
- add the following at the top of your /etc/apt/sources.list
deb http://us.archive.ubuntu.com/ubuntu/ natty main restricted universe
- as root, run the following:
apt-get update apt-get install linux-image-generic-pae linux-firmware
- make sure you install a boot loader in the new disk
And that's all it takes. You'll end up with your existing 10.04 installation running a recent kernel that supports the hardware on the X220.
Graphics
The recipe above will use the framebuffer for your graphic session. It is recommended that you install the intel driver from glasen as described here
