Difference between revisions of "How to improve harddisk performance"
(→Description) |
|||
| (4 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
| − | + | == Description == | |
| + | This tweak can increase the performance of your HDD by enabling DMA, IDE 32-bit I/O and setting the interrupt-unmask flag, which improves Linux's responsiveness. The last parameter sets the IDE Block Mode to fetch 16 blocks per I/O interrupt. Depending on your drive this value may vary (run hdparm -iI /dev/hda to find it out). | ||
| + | |||
| + | '''Caution:''' On some hard disks, inadvertent experimenting with hdparm options may corrupt the filesystem! Again, have a look into the man page of hdparm to find out if your model is affected. | ||
| + | |||
| + | On systems where the traditional ATA/(E)IDE and ATAPI stack is used, the following is appropriate: | ||
| + | |||
| + | <pre> | ||
| + | hdparm -d1 -c1 -u1 -m16 /dev/hda | ||
| + | </pre> | ||
| + | |||
| + | On newer systems with SATA hard drives (exposed e.g. as /dev/sda), only -d option is applicable, and it has no effect as DMA is already enabled. (An R61, interestingly, has a SATA HDD whilst the CD+DVD drive is connected via an IDE controller.) | ||
| + | |||
| + | You may also want to tune the acoustic setting (-M), power management mode (-B): for best performance, try -M254 and -B254). | ||
| + | |||
| + | == Successfully tested Thinkpad models == | ||
| + | The settings above have been successfully tested on the following models: | ||
| + | |||
| + | T20, T22, T23, T40 | ||
| + | |||
| + | Please add your model if missing. | ||
Latest revision as of 23:57, 10 November 2008
Description
This tweak can increase the performance of your HDD by enabling DMA, IDE 32-bit I/O and setting the interrupt-unmask flag, which improves Linux's responsiveness. The last parameter sets the IDE Block Mode to fetch 16 blocks per I/O interrupt. Depending on your drive this value may vary (run hdparm -iI /dev/hda to find it out).
Caution: On some hard disks, inadvertent experimenting with hdparm options may corrupt the filesystem! Again, have a look into the man page of hdparm to find out if your model is affected.
On systems where the traditional ATA/(E)IDE and ATAPI stack is used, the following is appropriate:
hdparm -d1 -c1 -u1 -m16 /dev/hda
On newer systems with SATA hard drives (exposed e.g. as /dev/sda), only -d option is applicable, and it has no effect as DMA is already enabled. (An R61, interestingly, has a SATA HDD whilst the CD+DVD drive is connected via an IDE controller.)
You may also want to tune the acoustic setting (-M), power management mode (-B): for best performance, try -M254 and -B254).
Successfully tested Thinkpad models
The settings above have been successfully tested on the following models:
T20, T22, T23, T40
Please add your model if missing.
